[bmw335d]

Originally Posted by suby01

Back to the topic. Has any super smart person figured out how to get this working?

ok so i got past the issue of the tail indicators not working.

So now i have the rear fog working and the indicator, unfortunately the outer indicator does not flash, only the inner one.

I am close

[glennbk]

Thankfully, you have on/off buttons. My old SAAB came on whenever you turned the fogs on.

[Ayyleoo]

Anyone code front fog light always on with lights ?

[lfdal54]

So, has the towel officially been thrown in on getting rear fogs working on an X3 LCI?

[vermethlln]

Originally Posted by voyagergab

Along the same subject .... why does BMW insist on installing red turn signals in North America, while everywhere else in the world they are amber?
That really annoys me

Same here.

[vermethlln]

Originally Posted by bmw335d

ok so i got past the issue of the tail indicators not working.

So now i have the rear fog working and the indicator, unfortunately the outer indicator does not flash, only the inner one.

I am close

I could use your code. I shipped my US G01 to Spain and I’m dying to get the rear fog lights enabled. I purchased and installed the euro light switch to the front. I press the rear fog light button but nothing comes on. I have BimmerCode but I don’t know the code to activate it. HELP!

[vermethlln]

Originally Posted by roxxor

So, good news and bad news. Firstly, sorry for the delay, had a family emergency come up on Thursday so I wasn't able to mess with the car at all until last night.

The good news is, I figured out the coding changes needed, which should work regardless of software version and without having to actually change the entire FA to ECE. The below changes are what worked for me and retained all normal functions for braking, reverse, and turn signal lights.

All changes are in the BDC_Body2 Module, in the 5FA9 Cafd file
NSL_Verbaut: Change this to "Verbaut"
LCE_BEL_LIN_VAR: Change to match your existing switch, plus "NSL". For example, mine was "28_BEL_PL_FLC_NSW", so I changed it to "34_BEL_PL_FLC_NSW_NSL". This keeps the incorrect light switch variant error from showing up in ISTA.
LIC_LOG_LAMP_2_OUTPUT_CHANNEL_DATA: Change this to "UNK_PARAM_2"
LIC_LOG_LAMP_2_OUTPUT_CHANNEL_INDEX: Change this to "UNK_PARAM_2"
LIC_NIVEAU_OVERRIDE_DATA_0: Change this to "G01_ECE_code2"
LIC_NIVEAU_OVERRIDE_INDEX: Change this to "G01_ECE_code2"
LIC_VERSION_DATA: Change this to "UNK_PARAM_11"

The bad news: It does require the switch with the actual rear fog button. After verifying it was working with the Euro switch, I attempted to use just the circuit board with the rubber contact from the US switch. The front fog lights continued to work normally, however the rear fog lights would not work. Switched back to the Euro switch, and the rear fogs worked fine. I believe as mentioned above there may be a difference in the circuit boards.

Photo of the working lights:

Can this be done with BimmerCode? I have the same problem. I brought a US G01 to Spain and I need the fog lights to be activated and the amber side markers to be disabled. Then it can pass the inspection. Can you help please?