09-18-2011, 12:13 AM | #1 |
Private
5
Rep 61
Posts |
Cold Air Intake
I have been trying to find a Cold Air Intake for a 2008 BMW X3 MT. So far nothing from Dinan, K&N, or AFE.
Anyone have any success or even tried to find a CAI for the X3? Not trying to be a "tuner" just get a little added torque from our X3. After that, might add a wide body throttle intake from Dinan and have a custom exhaust built. For now wanted to start off a little easy and then add a little more here and there. The 3.0 si cannot be chipped at this point. Even Steve Dinan says there's no more to get from ECU changes. So open for constructive/valid suggestions (other than a supercharger, too much money). |
09-20-2011, 02:47 PM | #2 |
Registered
0
Rep 4
Posts |
This might work...
http://www.**********s.com/aFe-Stage...BMW-E83-X3.htm Even thou I think its for the 3.0i and not the 3.0is.. Also I was looking, I think If I were to get one I would try to make a cosmos or an e90 06 330 one modified to work. I believe your 3.0is has the same motor as that car N52B30 this might also be worth a try http://www.jlevistreetwerks.com/3-Se...duct_info.html Last edited by kingrye; 09-20-2011 at 02:58 PM.. |
Appreciate
0
|
09-20-2011, 08:27 PM | #3 | |
Private
5
Rep 61
Posts |
Quote:
|
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|