BMW X3 Forum
BMW X3 Forum
Welcome to the ultimate BMW X3 community.
BMW Garage BMW Meets Register Search Today's Posts Mark Forums Read
XBimmers | BMW X3 Forum BMW X3 Forums | E83 (2003-2010) First Generation BMW X3 General Forum N52 Bosch new ignition coil problem

Post Reply
Thread Tools Search this Thread
      05-31-2014, 03:14 AM   #1

Drives: 2007 X3
Join Date: Jan 2014
Location: 95035

iTrader: (0)

Unhappy N52 Bosch new ignition coil problem

Hi all,

I recently have a misfiring ignition coil and am trying to change all 6 coils and spark plugs. (local BMW dealer diagnosed the misfire but I try to do the job myself)

Take a look at this summarizing video:

I just got these replacement ignition coils by Bosch from Pelican and change them on my '07 X3. After that, the engine can start but would stop within a few seconds.

I then put back the old coils and the engine ran fine again. As it seems, the problem has to do with the design of these new replacement coils. The boot for the spark plug is just way too air-tight, such that when inserted, the spark plug would get pushed out. The coils themselves aren't bolted to the engine and so the vibration from the engine has the tendency to push the coils out.

Note that the older, OE ignition coils(also by Bosch) have a tapered groove such that they can hold the top tip of a spark plug. Bu the newer coils don't have this groove to hold spark plugs

Any idea?
Thanks. Ben
Appreciate 0
Post Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 11:51 PM.

Powered by vBulletin® Version 3.7.0
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.,,,,,,,,, logo and trademark are properties of BIMMERPOST