09-23-2019, 04:26 AM | #1 |
Private
20
Rep 84
Posts |
wiper fluid spray
When I use wiper fluid spray, I find that a lot of the spray goes over my windshield and onto the top of the car. WTF? Is this the norm for everybody? Is there a way to adjust this?
|
09-23-2019, 04:29 AM | #2 |
Second Lieutenant
71
Rep 271
Posts |
Was a post on this a few days ago.
Check manual. You can adjust with small screws. An no, it's not normal that it goes over the windshield. But I assume you test it while driving? EDIT: Sorry, this was for a G02 X4. But probably same system. If not with screws, then use a needle or something to adjust the hole a bit downwards.
__________________
"It ain't much, if it ain't Dutch "
Last edited by The Dutch Joe; 09-23-2019 at 04:37 AM.. |
Appreciate
0
|
09-23-2019, 04:46 AM | #3 |
Private
20
Rep 84
Posts |
I'll take a look for that thread. I've tested it at highway speeds and at at about 10mph. Both had the same results. I'm glad this can be adjusted though.
|
Appreciate
0
|
09-23-2019, 09:08 AM | #4 |
Banned
27
Rep 108
Posts |
Should be the same for both cars, it's a torx screw that you turn to adjust. I did it on my G02 and adjusted them downward and their perfect now.
|
Appreciate
0
|
09-24-2019, 03:20 AM | #6 | |
Second Lieutenant
71
Rep 271
Posts |
Quote:
__________________
"It ain't much, if it ain't Dutch "
|
|
Appreciate
0
|
09-25-2019, 03:12 AM | #7 | ||
Jedi samurai ninja turtle
619
Rep 3,021
Posts
Drives: X3 M40i 2018
Join Date: May 2012
Location: Sydney, Australia
|
Quote:
|
||
Appreciate
0
|
09-25-2019, 04:26 AM | #8 | |
Second Lieutenant
71
Rep 271
Posts |
Quote:
Just give it a go
__________________
"It ain't much, if it ain't Dutch "
|
|
Appreciate
0
|
09-25-2019, 07:36 AM | #9 |
Banned
27
Rep 108
Posts |
When you turn the screw you will see the nozzle move just turn the screw in the direction you want the nozzle to move, believe it was counter clockwise to make it go down. Can't tell you the size but it was a small one.
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|