01-16-2019, 10:54 AM | #1 |
Registered
2
Rep 3
Posts |
Help! New to me x3 issues whistling noise and stalling
Hi everyone,
I just purchased a 2014 BMW X3 35i three months ago. Ive been having an odd issue with the car over the past few weeks. On startup it will rev very high for 30 seconds or so, and as the RPMs drop to the normal idle the car will sometimes stall out and I have to restart the car. Or if it put it into gear, the car will rough idle and jump a bit. Ive also noticed that sometimes there is decent power, and sometimes its like its lost some power when accelerating from a stop. Lastly I also noticed when accelerating slowly or decelerating slowly there is a whistling noise. I know the car has twin turbo, but im not pressing the gas hard. An example would be when going very slow through a parking lot. You can hear the whistling spin up and then down. This is very noticeable noise that was not there before. It sounds very much like the turbo but I dont think the turbo should be spinning up that much so soon? When the car was stalling i'd get a CEL light and the codes P00BD and P1020(01) The car seemed to drive better with the MAF unplugged so I changed out the MAF sensor. But im still having issues. Does anyone have any ideas? Ive read it could be a leak/vacuum issue. Someone said check the intake boot/elbow? But I cant find anywhere online where this party may be? Thank you in advance. |
01-16-2019, 12:27 PM | #2 | |
Captain
308
Rep 755
Posts |
Quote:
__________________
M3 E93
PORSCHE MACAN S: SOLD BMW X3 F25: SOLD AUDI S4: SOLD BMW E92 335: SOLD |
|
Appreciate
1
Riick135.50 |
01-16-2019, 01:25 PM | #3 |
Brigadier General
3443
Rep 4,102
Posts |
It does sound like a sensor issue of some sort. It could be related to timing, air flow, or something else but a sensor is not happy - bad sensor, or getting bad information based on something else like a leak.
Agreed w/ the above, if a specific sensor is being called out, try replacing it unless you can think of another reason it isn't working (corroded harness, broken wire, and so on). |
Appreciate
0
|
01-17-2019, 06:17 PM | #4 |
Second Lieutenant
39
Rep 228
Posts |
If power deliver is off too, I'd highly recommend having the car inspected and stop driving it. Failure of the eccentric shaft being neglected can caused further engine damage.
|
Appreciate
0
|
01-25-2019, 03:27 PM | #5 |
Registered
2
Rep 3
Posts |
The codes stopped after I changed the MAF sensor.
I took the car to the dealer and they found a cracked seal on the charge pipe after they did a smoke test. Thanks everyone for the help/suggestions. |
Appreciate
1
tracer bullet3442.50 |
01-28-2019, 08:32 AM | #6 |
Captain
308
Rep 755
Posts |
Thanks for updating the thread with solution!
__________________
M3 E93
PORSCHE MACAN S: SOLD BMW X3 F25: SOLD AUDI S4: SOLD BMW E92 335: SOLD |
Appreciate
0
|
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|