Here are some pics of the installation for those who are curious. I snapped these when replacing the unit with the turn signal as it failed on me and threw codes after about a week or so of use. Also, threw back on the summer wheels
This marks my 4th time doing the installation, and I was able to do this one module in less than an hour.
Take your wheel off and pop your hood.
Undo all these rivets to remove this covering.
Remove these rivets and bolts to release the wheel well liner.
Unscrew this Torx bolt that holds the headlight.
This one also secures the headlight so you can unscrew this. On this last go around, I unscrewed the bolt and left it in-place.
Unscrew these two bolts that secure the bumper to the fender. This will allow you to pull out the bumper partially.
Remove the bolt circled in red because it secures the headlight. The red arrow points to another Torx bolt situated deeper in the void. I believe this connects the bumper but I'm not positive (I went ahead and removed it anyways). You can remove the yellow Torx screws as well. Since I'm only doing one side, I only removed half on this side but if you're doing both I would remove them all.
This is the torx screw in the "void". [...]