Quote:
Originally Posted by ONLYA6
I replied with this info in another post but figured I would start a new thread since I've seen the topic arise a few times.
To keep the valves open:
- Start and put in Sport +
- Blip throttle to open
- Crawl under and unplug both actuators
They will remain in their last position until hooked back up.
You can buy a connector plug (or just seal the end up with tape) to keep dirt from getting it it, then just zip tie harness out of the way.
https://www.ecstuning.com/b-genuine-...r/18302411427/
UPDATED:
Found plug blanks for the actuators
https://www.wildwext.com/search?cont...h&s=7549032-02
I've done this on my M2 and X3M
|
I just did this on my 21' X3MC & it worked great! Taped up the plugs & used a zip tie to tuck the remaining wires from hanging down. It doesn't void any warranty does it? It hasn't been to the dealership yet, only have 2,300 miles on it. Just wanted to make sure before I take it into the dealership one day.