Quote:
Originally Posted by Kevin_The_Clean1
@BrockDM - Please post more photos & details about your engine bay cooling method at the track. Do you have any special mounts for those electric blowers... ?
|
Hey Kevin, sorry for the delay. The blowers are actually electric leaf blowers made by EGO, they are the 530CFM models. I took off the long attachment so I could fit it around the bay. I then slapped a zip tie onto the trigger so it runs on full power haha.
Strategy wise I just wanted to have active cooling around the trans tunnel to make sure that didn't get too hot after launching a few times (blower on the left).
Blower on the right was shooting towards the front of the block, various components up there and the heat exchangers to try and keep those cool after runs. Both blowers were just edged between the strut bar and side plastics, intake piping etc until they were snug enough to not fall over haha.
I don't have anymore photos at the moment unfortunately