|
Hi all!
First off, thank you for having me here, I am new to the BMW world but not new to cars, bikes, or wrenching on them.
Long story short, I was gifted a 2010 BMW X3 with a tick over 158k miles on it.
I got some of the parts, and did a bit of work on it. Changed the spark plugs, ignition coils, air filter, and cabin filter. Next up will be the transfer case actuator, transfer case fluid change, oil/filter change, and rear diff fluid change.
I got the Foxwell scan tool, and here are some of the error codes that came up, so I am looking for some advice/help on how to proceed.
ZKE Base Module 5 Fault 2
DME Engine Electronics Fault 6
LWS Steering Angle Sensor Fault 2
DSC/DXC Dynamic Stability Control Plus Fault 1
VGSC Transfer Box Fault 2
RDC Tire Pressure Monitor Fault 2
OC Seat Occupancy Passenger fault 1
ZAE multiple restraint system Fault 1
TELEFON Telematic Control Unit Fault 2
IM Light Module Fault 5
So where do I go from here?
Thank you all…
|