08-16-2021, 11:43 AM | #1 |
Registered
0
Rep 3
Posts |
Coding X3 RDC
Hello. I am fairly new to coding of my 2013 X3. I have the ENET cable, and E-SYS 3.27 along with FULL PSDZ Data (I think it is 188gb unzipped). Fresh Install of Windows 10.
So i have a bad RDC module and i need to code the replacement. I am following these two guides below, but the problem i am running into is it is not giving me an option to detect my I-STEP. https : // x3.xbimmers.com/forums/showthread.php?t=715297 https : // x3.xbimmers.com/forums/showthread.php?t=1276722 I am looking for suggestions on what i could be doing wrong. |
08-16-2021, 12:40 PM | #2 | |
Colonel
880
Rep 2,547
Posts
Drives: Z4MC-X3-35i-525i, Corrado G60
Join Date: Nov 2007
Location: MD
|
Quote:
Just be very careful what you are doing since it's possible brick modules when programming. If you haven't seen this guide, it might be helpful: E-Sys - Flashing ECU Guide v.1.0.1.pdf |
|
Appreciate
0
|
08-16-2021, 01:22 PM | #3 |
Registered
0
Rep 3
Posts |
Yes i meant PROGRAM it. The old module is dead, so no worry there and the new module i am hoping not to kill in the process. (Its the RDC module for my TMPS, So worst case, i dont have any TPMS sensors, not end of the world if i screw it up) I am not trying to program,upgrade my whole car because i am aware of those risks, and that is another discussion for another day.
That guide you sent is the one i am following and Step 8(c) is where things differ because i can SEE my istep in step 8(iv) but it doesnt show up under the other screen for 8(C). |
Appreciate
0
|
08-17-2021, 06:39 AM | #4 |
First Lieutenant
160
Rep 350
Posts |
I did this in the spring. I don't recall having to read the i-step level. Here are the basic steps I used. I am a bit fuzzy on the details.
Connect => Read FA (VO) => Activate FA (VO) => Read SVT (VCM) => Left-Click on RDC ECU => Click on "Detect CAF for SWE" => Select the CAFD from latest I-Level shown => Select OK => Right-Click on RDC ECU (the ECU itself not the underlying CAFD) => Select CODE I believe I used v3.31 and it was not necessary to use Launcher Pro for this particular operation. I also vaguely recall running across your issue and reading it was a bug in a particular version of E-sys. |
Appreciate
0
|
08-17-2021, 06:41 AM | #5 |
First Lieutenant
160
Rep 350
Posts |
|
Appreciate
0
|
08-18-2021, 06:47 AM | #6 |
Registered
0
Rep 3
Posts |
Okay everyone, i got this fixed finally. I had to use e-sys 3.30 to get this to work and the above link was the perfect information i needed.
https://f30.bimmerpost.com/forums/sh....php?t=1672330 |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|