03-11-2023, 02:46 PM | #1 |
Registered
0
Rep 1
Posts |
Running wires from cabin to engine bay in order to install LED bar
Hi,
I am installing a led bar and got the signal for relay using canm8 can-bus high beam relay. I found the proper can-wires from near the fuse box behind glove box and I am now trying to figure out how can I run the wires from there to engine bay? The car is 2016 BMW X3 F25 View post on imgur.com I found something (picture above) that apparently has cables inside it and goes through firewall but I don't think I can use that? Help would be really appreciated. Last edited by rahankuivaaja; 03-11-2023 at 02:52 PM.. Reason: added details about car |
03-18-2023, 03:01 PM | #2 |
Private First Class
22
Rep 104
Posts |
wiring
I installed lights and a camera in my 2013 F25 x3. Take a look under the hood, below the master cylinder. I think you will find you're in the correct place. I used a small knife like a pocket knife. Made a slit wide enough to push the snake through that plug. I caution you the smaller the slit the better then a little silicone to water tight it. I hope this helps
|
Appreciate
1
383vett625.50 |
Post Reply |
Bookmarks |
|
|