02-17-2014, 09:04 PM | #1 |
Private
20
Rep 99
Posts |
Cup holder removal - radar hardwire
Hi all - I'm in the process of hardwiring my Passport Max radar with a SmartCord direct wire kit. So far I've run the wire through the mirror bezel, behind the headliner at the windshield, behind the passenger A pillar cover and kick panel and under the dash knee panel. My goal is to mount the SmartCord control module to the centerstack panel in the cubby space behind the cup holders and tie into the 12 volt outlet. My next step is to run the wire through the console. I’ve figured out how to remove the centerstack panel above the cup holders. I’m looking for guidance on how to remove the cup holders so I can get access to the leads feeding the 12 volt outlet. I’m guessing that there are screws under the rubber inserts in the cup holders. Any insight would be appreciated.
|
02-17-2014, 09:44 PM | #2 |
_______
171
Rep 1,084
Posts |
I paid Best Buy $29 and they wired my Passport w/smart cable in my M3. Easiest install I ever did.
I haven't looked at removing the cup holder but I'd imagine you'd have to pop the center console trim off and start separating from there.
__________________
'13 35i M-Sport X3 | JB4 Stage 1 | BMS Intake | H&R Springs | Gloss black grill | CF Wrap and Coded by me | Recaro Child Seats
'15 M3 DCT AW/SO | JB Stage 1 | RKP Diffuser | P3 | M Perf Spoiler | iND Exterior Trim | Recaro Child Seat |
Appreciate
0
|
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|