|
The pure inlet is next to impossible to install on our cars. The OE inlet which you have to cut is very hard plastic and must be cut very close to the bend. Hardparker got it to work with some type of epoxy or JB weld. I went with the inlet made by AZ-MCRacer over on the F10 side of bimmerpost, but I also had to buy a new clean air pipe since the F10's is slightly different from ours.
If you want to try the Pure inlet, I have the one I tried to use and will be happy to send it over at a reasonable cost.
The DV is a quick mod if you have the turbo out of the car. Otherwise you're going to have to drain coolant + remove water pump to get access to all the bolts.
__________________
Current mods
Rockford Fosgate P3 // JBL MS-A5001 // MiniDSP
Ultra Racing Strut Brace // AFe Pro Dry S // PS2 // Custom Inlet // DV+ // FTP Boost Pipes // VRSF Race IC // VRSF Downpipe // ECUTek Protune @ 5280'
|