I contacted the seller as I'm interested as well.
Here is the response I got re: a couple questions I had about install.
Quote:
Installation is quite straightforward. You would need to replace the trunk handle with the trunk handle camera that we provide. Run the wire all the way to the front. Plug it to the module. Module has 2 harness. One is for power/can lines (which is PNP via a Y cable :-> here is why we say no wires cut/tapped) and another is the pin out directly to quadlock behind the CIC/NBT (video lines).
It will require coding. We can do remote coding. If you have an ENET cable, you can connect one end to your car and the RJ45 connector to your switch and enable port forwarding. Then all coding can be done swiftly.
|
I am pretty handy but I don't know if I'm up to pulling my dash apart.