Quote:
Originally Posted by JohnAG
Hi Shawn. I'm interested in coding my newly acquired 2016 28I MSport. I read the first instructions by April on what you need and how to set up, but it is 3 years old and I feel that some steps need to be expounded on. Following are my questions:
1. Where do I buy the ENET cable?
2. Where is the OBD connector located in the car?
3. Is there already a Mac version of the needed software (E-sys) and what is the most current software version?
4. Where do I get the psdzdata?
I hope you don't mind me too much asking these fundamental questions. I'm sure they've already been asked before, but the task of combing through 78 pages of the forum is daunting to me. Thanks.
|
1) Any ENET Cable off eBay or Amazon should work.
2) Driver's side under dash near trunk Release.
3) No. For Mac, must use Bootcamp or Parallels.
4) PM sent.