Quote:
Originally Posted by melquiades
Great!
How do you connect to the CIC? I cannot ping it..
are you using any specific static IP for the laptop and the CIC?
|
So this is from the first page...
Connect E-Sys to your Car:
Connect ENET cable between car's OBD port and network port of laptop.
Switch on the ignition of the car, don't start the engine.
You will notice laptop tries to connect to the car. Wait a few minutes until the network icon on laptop shows a Connection with the yellow exclamation point over it. If you don’t see the network icon due to your laptop settings, wait for a minute.
Start your E-Sys on your laptop.
Press connect button on top row of E-Sys to connect car with the laptop.
It opens up a dialog box.
Select the correct TargetSelector for your model of the car, e.g. F025 and not F025_DIRECT for X3 model.
Select "Connection via VIN" and press Connect.
Wait for the Connection message. Click OK. If the connection was established successfully you see the selected target in the status bar at the bottom.
Make sure you wait for that yellow exclamation before you open up E-Sys and make the "Connection via VIN"